Counterbore Tool

Counterbore Tools

Custom Manufactured to suite to your requirement.

Toonbank Bore ToolToonbank gebaar tools bied die voordele van weggooi-indeks in staat carbide inserts. Counter bore tools are offered in any size with single, double or triple cutting edges based on the size. Vrylik beskikbaar standaard metaal insetsels word gebruik. Pilots is afneem tipes, wat die gebruik van verskillende dae van vlieëniers vir dieselfde uur van die toonbank gebaar toelaat. Hierdie funksie kan ook 'n maklike vervanging van beskadigde / uitgediende vlieëniers. Maklik chip vloei te fasiliteer, goed ontwerpte gashes en verligting word op die instrument steel.

KENMERKE & SPECS:

  • Custom manufactured as per your requirement. Mention the required hole and counter-bore diameter and we will manufacture it for you.
  • Offered with tapered or straight shank.
  • Standard ISO grade indexable carbide carbide inserts used. Replacement inserts can be bought from a local tool shop.
  • Double or triple cutting edges provided so that feed per tooth can be increased for better speed and finish.
  • Guide pilots used to guide the tool and provide sufficient rigidity while cutting.
  • Guide pilots result in better concentricity.
  • Guide pilots are detachable type. You can use one counterbore tool for multiple holes by changing the guide pilot.
  • Detachable guide pilots can be easily replaced after getting worn out.
  • Engineered relief, typical to flutes of a drill provided for chips to flow out.
  • Manufacturing lead time of maximum 20 days.
  • Shipped to your door though air logistics.

VIDEOS van die werk of van die instrument : –

FILL IN THE CONTACT FORM TO GET A QUOTE

    Jou Naam (vereis)

    Jou e-pos (vereis)

    Hole Diameter (vereis)

    Counterbore Diameter (vereis)

    Shipping Address (vereis)

    Any Special Requirement?

    Enter the Captcha (Case-Sensitive)

    Meulkop met rigtingaanhegting

    COMBO COUNTERBORE DRILLS

    COMBO COUNTERBORE DRILL

    COMBO COUNTERBORE DRILL

    Counterboring or spot facing of holes after drilling requires tool change. Changing the tool after drilling each hole, so that counterbore & drills are concentric, proves to be a long tedious & time consuming job.

    We have developed a combination tool, which can drill and spot face/counterbore in the same go. No need of changing the tool each time. The tool comes with either HSS or carbide drills. The counterbore is done by standard indexable carbide inserts. This not only is a cheaper option but also a faster one.

    Standard straight shank drills can be used in this tool. The drills are held in place by side lock holding arrangement, where as the tool holder can have either a straight shank or a taper shank. The customer may choose which shank he needs.

    Ons ander tools wissel: Shenoy Engineering Tool Range

     

    Kontak ons ​​vir die produk inligting

      Jou Naam (vereis)

      Jou e-pos (vereis)

      Onderwerp

      Jou boodskap (vereis)

      Enter the Captcha (Case-Sensitive)

      Meulkop met rigtingaanhegting

      Kontak Besonderhede